Volkswagen Amarok 2.0L TDI Cylinder head semi assembled 908726 17VWAMAROK-A
17VWAMAROK-A- Inline 4-Cylinder, 16-Valve DOHC
- Common Rail Diesel.
- 2.0 TDI / BiTDI (16V): CDBA, CDCA, CKTB, CKTC, CKUB, CKUC, CNEA, CNFA, CNFB, and CSHA
- Features a defining, integrated water pipe located directly on the intake side of the casting.
- Volkswagen Amarok (2HA, 2HB, S1B, S6B, S7A, S7B / Pickup, Cab-Chassis)
- Volkswagen Crafter 30-35 / 30-50 (2E_, 2F_ / Van, Bus, and Platform/Chassis setups)
- For vehicles carrying the CKTB and CKTC engine codes, the 908726 casting is strictly restricted to models manufactured up until May 25, 2014
- Volkswagen OE:03L103065AV, 03L103351G, 03L103351N, 03L103351P, 03L103351Q, 03L103265E, 03L103265EX, 03L103265G, 03L103265H
This content will be shared across all product pages.
This VW Amarok cylinder head assembly 171612 fits the CDBA, CDCA, CSHA, CNEA, and CNFB engine codes commonly found in Amarok diesel models. Mechanics usually look for a head like this when the original one shows cracks along the water jackets or starts losing compression after an overheating event. It drops into the factory layout easily since the bolt pattern, ports, and coolant paths match the OE design.
Some owners notice their engines start rough in the morning or use more fuel than before—issues that often trace back to a worn or damaged head. In most cases, replacing the head solves these problems more confidently than trying to repair the old unit. This assembly gives you a clean start for the rebuild.
Another point worth mentioning is the way the surface sits flat, which helps the gasket hold once the head is torqued down. The internal passages follow the Amarok pattern, so airflow stays consistent with stock tuning. Workshops appreciate that it saves time because they don’t have to correct alignment issues or adjust anything unusual during installation.
Why buyers choose this VW Amarok cylinder head assembly
- Fits CDBA / CDCA / CSHA / CNEA / CNFB engines without modification
- Matches factory ports, mounting points, and coolant channels
- Holds compression well when installed with fresh gaskets and bolts
- Works for engines affected by cracks, overheating, or uneven wear
- Supports a smooth rebuild process for technicians and service centers
Most Amarok owners want their vehicle back on the road without repeat repairs. This head helps you achieve that by giving the engine a solid top-end base. With proper installation and clean components, it runs steady and keeps the engine operating the way it should.
Acme Impex checks casting quality and machining accuracy before dispatch, so you receive a part that sits correctly and supports trouble-free assembly. If you want a cylinder head that fits the Amarok diesel range properly and helps complete a dependable rebuild, this assembly is a practical choice.